Multiplex Technology 4CH Manual de usuario descargar pdf (Pagina 53)

•

Step 1

Connect the connector with the HDD (refer to Picture 1).

•

Step 2

Put HDD into the HDD cartridge. Please notice the bottom side is power side

as chart shows (refer to Picture 2).

•

Step 3

Screw the HDD to the cartridge. Before you screw the HDD, please be aware

that you must to level pin 1 of the HDD at pin 1 mark, because the screw hole is

different from different HDD brands. Then screw the HDD correctly (refer to Picture 3

and 4). You must precisely align the hard disk to the pin connection to ensure correct

installation.

•

Step 4

Reverse the HDD and put it into DVR (refer to Picture 5 and 6).

•

Step 5

Connect the HDD with DVR (refer to Picture 7).

•

Step 6

Lock the cabinet by turning the key clockwise (refer to Picture 8).

A ( locked )

B ( unlocked )

•

Step 7

Close the cap (refer to Picture 9).

4CH

Carefully following the steps to ensure correct installation.

*** Note: Please set one HDD to “Master Mode” or “Single Mode” ***

Note : If you do not lock the cabinet, the DVR system will not function properly.

1 2 ... 48 49 50 51 52 53 54 55 56 57 58 59 60

Sin comentarios

Multiplex Technology 4CH Manual de usuario Pagina 53